IronPort - Configuration Guide - AsyncOS 7.6.1

Chapter 9 Anti-Spam
Editing a Relay
Deleting a Relay
OL-25136-01
Figure 9-17 Add Relay Page
Step 2 Enter a name for the relay.
Step 3 Enter an IP address for the relay. For more information about valid IP address entries, including IPv6
address formatting, see IP Addresses, page 9-22.
Step 4 Select a header type (Custom or Received). For more information about custom headers, see Custom
Header, page 9-22. When entering a header, you do not need to enter the trailing colon.
For custom headers, enter the header name.
For Received: headers, enter the character or string after which the IP address will appear. Enter the
number for the “hop” to check for the IP address. For more information, see Received Header,
page 9-23.
Step 5 Commit your changes.
Step 1 Click on the relay’s name in the Incoming Relay page. The Edit Relay page is displayed.
Step 2 Make changes to the relay.
Step 3 Commit your changes.
Step 1 Click on the trash can icon in the corresponding row for the relay you want to delete. You are prompted
to confirm the deletion.
Step 2 Click Delete.
Step 3 Commit your changes.
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
9-27