EWPAA Structural Plywood and LVL Design Manual - Engineered ...

REFERENCES CITED:1. AS 1720.1-1997, Timber Structures, Part 1 : Design Methods.2. Limit States Timber Design to AS 1720.1-1997 : An introduction to Member Sizing using theAustralian Limit State Design Code. Boughton, G.N. and Crews, K.I. Standards Australia, 1998.3. Nailed Joints in wood Structures, Ehlbeck, J. Virginia Polytechnic Institute and State University,Blacksburg, Virginia, USA, 1979.4. Timber Joint Design – 3, Bolts, Coach Screws and Timber Connectors, National Association ofForest Industries, 1989.5. AS/NZS 1170.0:2002, Structural Design Action.6. Developments in the Design of Timber Joints, Hilson, B.O. and Whale, L.R.J. The StructuralEngineer. Volume 68/No.8, 1990.7. Fastenings, Soltis, L.A. Chapter 7, Source unknown.8. Multiple Fastener Timber Connections with Dowel Type Fasteners, Jorrisen, A. Proc. of PacificTimber Engineering Conference, Rotorua, N.Z., 1999.9. Design Concepts for Nailed and Screwed Joints, Aune, P. Source unknown.10. Bolted Wood – Joint Yield Model, McLain, T.E. and Thangjitham, S. Journal of StructuralEngineering, Vol. 109, No. 8, 1983.11. Simplified Design of Joints with Dowel – Type Fasteners, Blass, H.J. Ehlbeck, J. and Rouger, F.Proc. of Pacific Timber Engineering Conference, Rotorua, N.Z., 1999.12. Review of Current Structural Timber Jointing Methods – an Architectural Perspective,Charleston, A.W. and Patience, D.B., School of Architecture, Victoria University of Wellington, NewZealand Timber Design Journal, Issue 3, Vol. 2, 1993.217