Card_Value_Center_Us.. - Smart Vend Corporation

SchlumbergerCard Value Center User's GuideThis panel illustrates the panelwith the cut-out for the A/Ccord.Blank-out PanelRear Base PlateFigure 3-3:Installing the Rear Base Plate andBlank-out PanelsMounting the Floor StandCard Value Centers can be purchased with an optional floor stand for mounting. Usethe following instructions to mount the CVC Floor Stand to the floor.1 Remove the front and rear base covers (if applicable).2 If the floor stand is to be placed away from the wall, attach the rear base plate tothe floor stand using the three 1 4 - 20 attaching bolts with lock washers. Securelytighten the bolts. (See Figure 3-3.)3 Using the floor stand base as a template, mark the position of the eight mountingstuds on the floor.4 Using a 3 4" Masonry bit, drill holes in the floor to a depth of 2 1 4" at each of the eightpositions marked.5 Install a lag-shield in each hole (supplied with the kit).6 Align the floor stand base over the holes, then secure the floor stand to the floorusing the eight 2" x 1 2" screws with flat washers (supplied). (See Figure 3-4.)CVC to Floor Stand Instructions1 Remove the access panel from the floor stand. (See Figure 3-4.)W A R N I N G:Do not proceed with mounting the CVC to the floor stand, unless the stand is securelybolted to floor the as described above.2 Hold the CVC unit above the floor stand, this requires two-to-three people forsafety, then route the A/C cord into the lower section of the stand through thecable cut-out in the top. (See Figure 3-4.)3 Align the mounting holes in the CVC case (B) with the six mounting studs on thefloor stand mounting bracket (A), then rest the unit on the studs. (See Figure 3-4.)Mounting the Unit Hardware Setup 3-5