E Snake Manual - Whirlwind

More documents

Recommendations

Info

1. Open CobraNet Discovery (Disco) and Select - 2. Select the network adapter that is connected to the CobraNet network.3. Uncheck . If the correct IP range is not filled in, click .This should automatically assign the start and end addresses of 169.254.1.2 and 169.254.1.199. If itdoes not, manually enter these two figures into the Start and End boxes.4. Re-check
5. Disco should find the devices on the network and assign IP addresses within the specifiedrange.(Note: If devices are already active on the network and have previously been assigned IP addressesoutside of this specified range, it will be necessary to do one of the following:a) Return to the section for your operating system in section 3.3 and reassign an IP address to thePC that is one number below the lowest address within the range of the devices on the network asdisplayed in DiscoORb) <strong>Manual</strong>ly reassign IP addresses within the specified range to each to each device found on thenetwork by performing the following:• Right-click on the device in the Disco screen, select .
Page 1 and 2: SYSWhirlwind’s Family of Digital
Page 3 and 4: 4.3 Output boards .................
Page 5 and 6: 1. E Snake System OverviewThe main
Page 7 and 8: 1.3 Automatic ES Operating Paramete
Page 9 and 10: Large Blue Light indicates unit is
Page 11 and 12: Analog AudioAudio connections are m
Page 13 and 14: A Fully Loaded E Snake Frame2.2 Inp
Page 15 and 16: 3. E Snake ControlIMPORTANT - ROUTE
Page 17 and 18: groups of computer networks. It was
Page 19 and 20: 4. Right-click - Click do NOT acc
Page 21 and 22: server. This feature eliminates the
Page 23 and 24: 7. Make sure that “Obtain an IP a
Page 25: The computer is now set up to autom
Page 29 and 30: 3. Select the proper Network Adapte
Page 31 and 32: Select a file from the “Most rece
Page 33 and 34: The Overview Window can consist of
Page 35 and 36: Figure 2 MLI Channel Detail PageSel
Page 37 and 38: 3.4.4 Transformer Mic Input (TRMI )
Page 39 and 40: Identifies the sample rate of the i
Page 41 and 42: 7. Click the button. The firmware
Page 43 and 44: Although CobraNet can be networked
Page 45 and 46: Architecture Editor ScreenThis scre
Page 47 and 48: 20-bit resolution with 2 Tx and Rx
Page 49 and 50: 5. Examples of typical applications
Page 51 and 52: Resulting Overview Screen for Basic
Page 53 and 54: 4-box, 64 x 32, 24-bit Architecture
Page 55 and 56: allowing all physical connections a
Page 57 and 58: 2 - Stage Festival Setup, “Stage
Page 59 and 60: Broadcast and Recording Architectur
Page 61 and 62: E Snake As Access Point To A CobraN
Page 63 and 64: E Snake As Input To A Digital Conso
Page 65 and 66: Architecture Editor Screen for Basi
Page 67 and 68: Changing the complement of input an
Page 69 and 70: 7.3.3 “CobraNet Discovery Uninsta
Page 71 and 72: Appendix A.ES UNIT LCD Display Mess
Page 73 and 74: (Blink Code)Error Name(54) FLASH Bu
Page 75 and 76: Error NameCM-1 Watchdog Error(Fault
Page 77 and 78:
Ethernet A Local Area Network (LAN)
Page 79 and 80:
Switching Hub A Switching Hub, or s
show all

E Snake Manual - Whirlwind

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?