FMDR Technical Handbook.pdf - Omni Metalcraft Corp.

FLAT MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOKZERO-PRESSURE CONTROLS: POWER DISTRIBUTION WIRINGPOWER DISTRIBUTION WIRINGPOWER DISTRIBUTION WIRING24V DC power is distributed along the conveyor frame to each ZPA module as show in the figure above. Thepower distribution wiring system contains the following components: 24VDC Power Supply Power Distribution Trunk Line Wiring Isolation Connectors Patch Cables Terminating Caps24VDC POWER SUPPLYThe 24V DC power supply converts the plant line voltage. The 24V DC power supply must be configured to theline voltage of your plant. Confirm that the power supply is correct for the plant line voltage before applying ACpower. Depending upon the application, flat motor conveyor may include 1 or more 24V DC power supplies.SPECIFICATIONSNominal AC Input Voltage: Single Phase (100-240V), Three Phase (3 x 400-500V)Frequency: 47-63 HzNominal DC Output Voltage: 24VDC +/- 2%Operating Temperate: (0 deg. F-80 deg. F @ 20amp), (0 deg. F-115 deg. F @ 5-10 Amps)Environment Protection: NEMA 12Current Limitation: 150% of Pout max @ 1 sec.The recommended maximum cycle rate for the power supply is one per hour.Depending upon 24V DC power supply size and plant line voltage, each power supply will draw a maximumcurrent as indicated in the chart below:FLA @ 115V FLA @ 230V FLA @ 460V10 AMP 2.4A 1.2A 0.6A20 AMP 4.8A 2.4A 1.0A40 AMP 9.6A 4.7A 2.5AFMDR TECHNICAL HANDBOOK 2014.126