FMDR Technical Handbook.pdf - Omni Metalcraft Corp.

FLAT MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOKCONTROLS: PREPARING FOR INITIAL START-UP1) Review pages 7 and 8 prior to starting any equipment.2) Verify that conveyor sections, leg supports, etc. were installed properly.3) Verify that all zone-to-zone cabling is connected properly.4) Verify that all sensor cabling is connected properly.5) Verify that conveyor is not loaded with product.6) Verify flat motors are securely bolted to side frame.7) Verify all slave rollers are attached to flat motor drive sheaves with proper drive bands.8) Check all flat motors, photo-eyes and drive modules for proper wiring.9) Check all drive module DIP switch settings. (DIP switches must be set before supplying power to drivemodules)10) Verify correct power supply sizing and distribution.11) Verify power supply DC Grounds are connected if multiple power supplies are utilized in ZPA system.12) Verify power supply line voltage is correct to voltage on name plate (SCCR panel sticker) before powering up.FMDR TECHNICAL HANDBOOK 2014.143