FMDR Technical Handbook.pdf - Omni Metalcraft Corp.

More documents

Recommendations

Info

FLAT MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOKDRIVER CONTROLS: I/O CONNECTIONS (Continued)LEAD WIRES FROM REMOTE LOGICSMART INPUT 1POWER WIRESMART OUTPUT 1SMART INPUT 2SMART OUTPUT 2See page 22 I/O connections section for proper use of devices connected to Smart I/O.<strong>FMDR</strong> TECHNICAL HANDBOOK 2014.142
FLAT MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOKCONTROLS: PREPARING FOR INITIAL START-UP1) Review pages 7 and 8 prior to starting any equipment.2) Verify that conveyor sections, leg supports, etc. were installed properly.3) Verify that all zone-to-zone cabling is connected properly.4) Verify that all sensor cabling is connected properly.5) Verify that conveyor is not loaded with product.6) Verify flat motors are securely bolted to side frame.7) Verify all slave rollers are attached to flat motor drive sheaves with proper drive bands.8) Check all flat motors, photo-eyes and drive modules for proper wiring.9) Check all drive module DIP switch settings. (DIP switches must be set before supplying power to drivemodules)10) Verify correct power supply sizing and distribution.11) Verify power supply DC Grounds are connected if multiple power supplies are utilized in ZPA system.12) Verify power supply line voltage is correct to voltage on name plate (SCCR panel sticker) before powering up.<strong>FMDR</strong> TECHNICAL HANDBOOK 2014.143
Page 1 and 2: FMDR TECHNICAL HANDBOOK 2014.1FMDR
Page 3 and 4: FLAT MOTOR DRIVEN ROLLER CONVEYOR S
Page 19: FLAT MOTOR DRIVEN ROLLER CONVEYOR S
Page 41: FLAT MOTOR DRIVEN ROLLER CONVEYOR S
Page 53: FMDR TECHNICAL HANDBOOK 2014.153

FMDR Technical Handbook.pdf - Omni Metalcraft Corp.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?