FMDR Technical Handbook.pdf - Omni Metalcraft Corp.

More documents

Recommendations

Info

FLAT MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOKZERO-PRESSURE CONTROLS: POWER DISTRIBUTION WIRINGPOWER DISTRIBUTION WIRINGPOWER DISTRIBUTION WIRING24V DC power is distributed along the conveyor frame to each ZPA module as show in the figure above. Thepower distribution wiring system contains the following components: 24VDC Power Supply Power Distribution Trunk Line Wiring Isolation Connectors Patch Cables Terminating Caps24VDC POWER SUPPLYThe 24V DC power supply converts the plant line voltage. The 24V DC power supply must be configured to theline voltage of your plant. Confirm that the power supply is correct for the plant line voltage before applying ACpower. Depending upon the application, flat motor conveyor may include 1 or more 24V DC power supplies.SPECIFICATIONSNominal AC Input Voltage: Single Phase (100-240V), Three Phase (3 x 400-500V)Frequency: 47-63 HzNominal DC Output Voltage: 24VDC +/- 2%Operating Temperate: (0 deg. F-80 deg. F @ 20amp), (0 deg. F-115 deg. F @ 5-10 Amps)Environment Protection: NEMA 12Current Limitation: 150% of Pout max @ 1 sec.The recommended maximum cycle rate for the power supply is one per hour.Depending upon 24V DC power supply size and plant line voltage, each power supply will draw a maximumcurrent as indicated in the chart below:FLA @ 115V FLA @ 230V FLA @ 460V10 AMP 2.4A 1.2A 0.6A20 AMP 4.8A 2.4A 1.0A40 AMP 9.6A 4.7A 2.5A<strong>FMDR</strong> TECHNICAL HANDBOOK 2014.126
FLAT MOTOR DRIVEN ROLLER CONVEYOR STRAIGHT AND CURVE TECH HANDBOOKZERO-PRESSURE CONTROLS: POWER DISTRIBUTION WIRING (Continued)POWER DROPPOWER DISTRIBUTION TRUNK LINE WIRINGPOWER DISTRIBUTION TRUNK LINE WIRINGFrom the 24VDC power supply, the trunk line wiring delivers power along the side frame to each of the ZPAmodules. Depending upon the application, the trunk line cable may have single power drops or up to five powerdrops on a single cable. Three power drops are shown in the diagram above. During installation, the quickdisconnects at the ends of the power distribution trunk line must be connected to the adjacent conveyor. Thepower drops are connected to the ZPA module as shown in the diagram below.ZONE PHOTO EYEMOTORWIREBLACK WIRE CONNECTEDTO (-) TERMINALRED WIRE CONNECTEDTO (+) TERMINALPOWER WIRE<strong>FMDR</strong> TECHNICAL HANDBOOK 2014.127
Page 1 and 2: FMDR TECHNICAL HANDBOOK 2014.1FMDR
Page 3 and 4: FLAT MOTOR DRIVEN ROLLER CONVEYOR S
Page 19: FLAT MOTOR DRIVEN ROLLER CONVEYOR S
Page 25: FLAT MOTOR DRIVEN ROLLER CONVEYOR S
Page 53: FMDR TECHNICAL HANDBOOK 2014.153

FMDR Technical Handbook.pdf - Omni Metalcraft Corp.

Create successful ePaper yourself

Delete template?

Save as template?