Operating and Installation Instructions Display device KERN KFS-T

More documents

Recommendations

Info

Call up menu: Switch-on balance and during the selftest press .Ensure that there are no objects on the weighing pan.Reset to zero if necessary by pressing . Go to weighing mode and press and hold for approx. 5-6 seconds untilFUNC followed by F0 iSn appears. Release button. Pressrepeatedly until F2 dm is displayed. Press and select the set weighing scales type by .= Single-range balance= Dual range balance= Multi-interval balance Acknowledge with . Pressrepeatedly until „CAL“ will be displayed. Acknowledge by and select desired setting with .= Linearization= Adjustment14 KFS-T-BA_IA-e-1213
Carry out adjustment: Confirm menu setting nonLin with .Ensure that there are no objects on the weighing pan. LoAd will be displayed after standstill control has been carried out. Put the required adjustment weight carefully in the centre of the weighing pan. After successful adjustment, the weighing scales will carry out a self test. Duringthis self test remove the adjustment weight and the weighing scales willautomatically return to weighing mode.An adjusting error or incorrect adjusting weight will be indicated by the errormessage; repeat adjustment procedure.KFS-T-BA_IA-e-1213 15
Page 4 and 5: 1 Technical dataKERNDisplayDivision
Page 6 and 7: 2.1 Overview of displayWeight displ
Page 8 and 9: 2.2 Keyboard overviewKeyFunction Tu
Page 10 and 11: 3.4 Monitoring of Test ResourcesIn
Page 12 and 13: 6.3 Unpacking/installationCarefully
Page 16 and 17: 6.6 LinearizationLinearity shows th
Page 18 and 19: 7 Operation7.1 Start-up Press and t
Page 20 and 21: 7.6.1 Determination of the average
Page 22 and 23: 7.7 TotalizationAdding-up during we
Page 25 and 26: Display and output sum „Total“:
Page 27 and 28: 7.7.2 Automatic adding-upWith this
Page 30 and 31: Activate function For menu setting
Page 32 and 33: 7.8.1 Tolerance check for target qu
Page 34 and 35: 7.8.2 Tolerance check for target we
Page 36 and 37: Start tolerance check Place load an
Page 38 and 39: Change settingsConfirm selected men
Page 40 and 41: F9 PAParity42 Pr0* No parity bit44
Page 42 and 43: 9.1 Printer modePrintout example (K
Page 44 and 45: 11 Error messages, troubleshooting
Page 46 and 47: 12.3 How to connect the platform Di
Page 48 and 49: Change settingsConfirm selected men
Page 50 and 51: Dual range balanceConfirm with, the
Page 52: 13 Declaration of conformityEG-Konf

Operating and Installation Instructions Display device KERN KFS-T

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?