Operating and Installation Instructions Display device KERN KFS-T

More documents

Recommendations

Info

7.8.1 Tolerance check for target quantity Activate menu setting „F0 sel / SEL 2“, see chap.7.8 „Activate function“.Set limit values Pressto display the lower limit including current setting.If required, delete the current setting by pressing . Use the numeric keys to enter the quantity for the lower limit (such as 70 units)and confirm by pressing .The upper limit will be displayed with the current setting.Delete with if necessary. Use the numeric keys to enter the quantity for the upper limit (such as 80 units)and confirm by pressing .32 KFS-T-BA_IA-e-1213
Start tolerance check Specify unit weight, see chap. 7.6.1 or 7.6.2 Place load and wait until tolerance margin [] appears. With the help of theindicator check if the weighed goods are under, inside or over the defaulttolerance.Depending on the setting in the menu an additional audio signal may be sounded.Target quantity below tolerance:Target quantity within tolerance:Target quantity exceeds tolerance:KFS-T-BA_IA-e-1213 33
Page 4 and 5: 1 Technical dataKERNDisplayDivision
Page 6 and 7: 2.1 Overview of displayWeight displ
Page 8 and 9: 2.2 Keyboard overviewKeyFunction Tu
Page 10 and 11: 3.4 Monitoring of Test ResourcesIn
Page 12 and 13: 6.3 Unpacking/installationCarefully
Page 14 and 15: Call up menu: Switch-on balance and
Page 16 and 17: 6.6 LinearizationLinearity shows th
Page 18 and 19: 7 Operation7.1 Start-up Press and t
Page 20 and 21: 7.6.1 Determination of the average
Page 22 and 23: 7.7 TotalizationAdding-up during we
Page 25 and 26: Display and output sum „Total“:
Page 27 and 28: 7.7.2 Automatic adding-upWith this
Page 30 and 31: Activate function For menu setting
Page 34 and 35: 7.8.2 Tolerance check for target we
Page 36 and 37: Start tolerance check Place load an
Page 38 and 39: Change settingsConfirm selected men
Page 40 and 41: F9 PAParity42 Pr0* No parity bit44
Page 42 and 43: 9.1 Printer modePrintout example (K
Page 44 and 45: 11 Error messages, troubleshooting
Page 46 and 47: 12.3 How to connect the platform Di
Page 48 and 49: Change settingsConfirm selected men
Page 50 and 51: Dual range balanceConfirm with, the
Page 52: 13 Declaration of conformityEG-Konf

Operating and Installation Instructions Display device KERN KFS-T

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?