Fire-Lite Alarms MS-9600 Addressable Fire Control Panel

3.3 Initial Power-upUser Programming LevelsThere are two user programming levels:• User Master Program Level 1 is used for programming panel specific datarelating to device types, zoning, messages, control panel functions, etc.• User Maintenance Program Level 2 is used by a qualified operator to accessfeatures such as Disable/Enable, View and Clear History, Walktest and SystemTime Change.The following sections describe the initial programming procedures for a new system.The same procedures are used to modify programming in an existing system.After completing the wiring of addressable devices to the SLC, apply power to thecontrol panel. If the addressable devices have not yet been programmed into the FACP,their LEDs will not flash and the following trouble message will be displayed.TROUBL IN SYSTEMNO DEVICES INSTALLED09:03A 0108013.4 Programming Screens DescriptionSee PageTwo main options are available when the Enter key is pressed: Read Status andProgramming. Each option has multiple functions or features which may be chosen.To view all of the choices, it is necessary that the programmer scroll through a numberof additional subscreens. These selections are displayed on multiple screens to makethem more readable for the programmer. Refer to "Master Programming Level" onpage 42, for additional information on the various screens.The title of the main option screen will always be displayed at the top of the subscreensfor the programmer’s convenience. If additional subscreens exist, an Up or Downarrow will be displayed in the upper right corner of the screen being viewed. Theprogrammer can then press the keypad Up or Down arrow key to view the newsubscreen. To select one of the choices in a screen, the programmer presses the keypadnumerical key corresponding to the desired choice.Note that subscreens may also have multiple options which require viewing more thanone screen. The same process, as detailed in the previous paragraphs, is followed toview all option choices.3.5 Programming and PasswordsSee PageThere are two factory set programming passwords which will access the Programmingscreens as indicated in the following examples. From either of the screens, access tospecific system and device features or programming may be obtained. All userprogramming entries are stored in nonvolatile memory. The factory set passwords canbe changed by the user as described in "Password Change" on page 93. If an invalidpassword is entered, the blinking cursor will return to the first password characterposition. To exit Programming or Read Status mode at any time, press the ESC(Escape) key repeatedly. Note that Programming mode must be exited using the ESCkey in order to store the program data entered during this mode. If the Reset key ispressed or power is lost before exiting Programming mode, the data just entered willnot be saved.