Fire-Lite Alarms MS-9600 Addressable Fire Control Panel

✓ Select PAS Yes when editing the detector set to address 005✓ Program the desired zone or zones to be activated by this detector, in thisexample Z001✓ Program an output, such as a control module that is to be activated by detector005 by assigning the same zone to it; in this example Z001✓ Program an output, such as a control module, for PAS activation by assigningzone Z97 to it. This control module may be connected to a signaling deviceused to indicate a PAS condition (do not use a Notification Appliance Circuitfor this purpose)✓ Enable zones Z001 and Special Purpose Zone PAS 97 and set the PAS delaytimer to some valueEDIT DETECTOR1=WALKTEST2=PAS3=PRE-SIGNALEdit Detector Screen #3See PageTo enable the Pre-signal feature,press 3 while viewing Edit Detector Screen #3 until the display reads Pre-signalYes. Each press of the 3 key will cause the display to toggle between Pre-signal Yesand Pre-signal No. Refer to .✓ Select Pre-signal Yes when editing the detector set to address 005✓ Program the desired zone or zones to be activated by this detector, in thisexample Z001✓ Program an output, such as a control module that is to be activated by detector005 by assigning the same zone to it; in this example Z001✓ Program an output, such as a control module, for Pre-signal activation byassigning zone Z98 to it. This control module may be connected to a signalingdevice used to indicate a Pre-signal condition ✓ Enable zones Z001 and Special Purpose Zone Pre-signal 98 and set the Presignaldelay timer to some value