Megatouch FORCE Touchscreen Replacement

COPYRIGHT © 2004 MERIT INDUSTRIES, INC.DRILLEDHOLES(5 PER SIDE)FIGURE 15 - FORCE FUSION - PLASTIC MOUNTING PIECES ON BEZELside the CPU door along the bottom ofthe bezel and the 3 wing nuts insidethe game along the top piece (after removingthe rear door). Then disconnectthe 2 speaker connectors insidethe game on either side of the marqueebefore lifting the bezel from the game.Upright without coin door: Unlockand open the front bezel (see Figure16).3. Remove the black poly tape (see Figure16) from around the edges of theold touchscreen, keeping the mannerin which the tape was placed aroundthe screen in mind.4. Remove the two nuts and washers securingthe touchscreen controller to thegame and remove the controller fromthe mounting screws. Then disconnectthe cable from the back of thecontroller and disconnect the Molexconnector (orange and gray wires)running from the touchscreen controllercable to the main power harness.5. Use dental floss to carefully cut thefoam tape holding the touchscreen tothe picture tube until you are able tocompletely remove the touchscreen.6. Remove any remaining adhesive residuewith denatured alcohol, then wipethe surface of the picture tube with thesupplied alcohol wipe.Touchscreen Installation7. Clean the reverse side of the replacementtouchscreen with the supplied alcoholwipe.8. Peel the backing from the 8 pieces ofdouble-sided foam tape already adheredto the reverse side of thetouchscreen.9. Replace the new touchscreen over thepicture tube (with the cable on the rightPM0331-04 MEGATOUCH FORCE TOUCHSCREEN REPLACEMENT 16