Megatouch FORCE Touchscreen Replacement

COPYRIGHT © 2004 MERIT INDUSTRIES, INC.if you are facing the game), making surethe screen is properly and evenlyaligned over the picture tube. Thenclean the front of the screen with thesupplied alcohol wipe.10. Connect the new touchscreen controllercable in the back of the controllerand secure the controller on the mountingscrews in the game with the existinghardware. Also connect the Molexconnector (orange and gray wires) tothe main power harness.11. Remembering the manner in which thetape was placed around the touchscreenyou removed, place and cut alength of the supplied black poly tapeevenly over an entire edge of the touchscreenand repeat until all 4 edges arecovered.12. Place and cut a longer length of blackpoly tape around all 4 edges of thescreen.13. Plug in and turn on the game.14. When the game is finshed booting, calibratethe touchscreen.15. Close and lock the front bezel. Forupright games with coin doors, replacethe bezel and secure it with the 5 wingnuts removed earlier. Also reconnectthe 2 speaker connectors, then replacethe rear door.MEGATOUCH COMBO JUKEBOXTouchscreen Removal1. Turn off and unplug the game.2. Unlock and remove the rear door andturn off the internal power switch (locatedabove the cooling fan on the leftside).3. Using Figures 17 and 18, remove the 6bolts and wing nuts (3 per side) fasteningthe front bezel to the cabinet andremove the bezel.4. Using Figure 19, locate the touchscreencontroller mounted inside thecabinet on the right side (if you are facingthe rear of the game) and removethe two screws fastening the controllerto the cabinet. Then disconnect theMolex connector (orange and graywires) running from the touchscreencontroller cable to the main power harness.5. Remove the black poly tape from aroundthe edges of the old touchscreen (seeFigure 20). Remember how the tapewas placed in order to tape the newtouchscreen.6. Use dental floss to carefully cut thefoam tape holding the touchscreen tothe picture tube until you are able tocompletely remove the touchscreen.7. Remove any remaining adhesive residuewith denatured alcohol, then wipethe surface of the picture tube with thesupplied alcohol wipe.Touchscreen Replacement8. Clean the reverse side of the replacementtouchscreen with the supplied alcoholwipe.9. If there is no tape already on the touchscreen,cut pieces of the supplied 1/2”foam tape long enough to cover eachedge of the screen without overlapping.After the tape is in place on thescreen, peel off the backing.10. Replace the new touchscreen over thePM0331-04 MEGATOUCH FORCE TOUCHSCREEN REPLACEMENT 18