Q150T S/E/ES Sample Preparation System Instruction Manual
Q150T S/E/ES Sample Preparation System Instruction Manual
Q150T S/E/ES Sample Preparation System Instruction Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7.2.1 Shaping Carbon Rods<br />
<strong>Q150T</strong> <strong>Sample</strong> <strong>Preparation</strong> <strong>System</strong><br />
WARNING<br />
It is essential that you shape the tips of the carbon rods to the correct<br />
profile to minimise the possibility of damage to the instrument due to<br />
excessive currents.<br />
We recommend that you shape the rods so that one is sharpened to 1.4mm diameter x<br />
5mm long and the other is flattened as shown in Figure 7-4.<br />
Figure 7-4. Recommended Carbon Rod shapes<br />
The accessory pack contains a rod shaper (see Figure 7-5) that will accept 3mm and<br />
6mm rods. To enable the shaper to accept 6mm rods, remove the collet by unscrewing<br />
the collet screw and pulling the collet out.<br />
Insert rod<br />
Collet<br />
Figure 7-5. Carbon Rod Shaper (S8650/S8651))<br />
To shape a carbon rod:<br />
Thumbscrew Dimple<br />
1. Cut a 50mm length of rod.<br />
Use only Quorum rods due to the varying diameter and quality of other<br />
manufacturer’s rods. Quorum supply rods in two sizes: 3mm (C5422)<br />
and 6mm (C5423).<br />
2. Hold the shaper stationary and insert the carbon rod from the bottom to half way<br />
through the window, as indicated by the dimple at the bottom of the hole.<br />
3. Gently tighten the thumb screw to hold the carbon rod in place.<br />
4. Holding the shaper body and, with<br />
very little force, gently turn the<br />
black knob on the end of the shaper<br />
clockwise (when viewed face on).<br />
5. Keep turning the knob until the tip<br />
of the rod touches the other side of<br />
the hole in the cutter as shown<br />
opposite. Clear the carbon rod dust<br />
as necessary.<br />
6. Undo the thumb screw and<br />
withdraw the rod carefully to avoid<br />
damaging the newly formed tip.<br />
Cutters<br />
Collet screw<br />
Shaper body Black<br />
knob<br />
10473 - Issue 3 52 <strong>Q150T</strong> - <strong>Instruction</strong> <strong>Manual</strong>