Volume 3 nr 1 / 2011 - Academia Oamenilor de Stiinta din Romania

More documents

Recommendations

Info

126 Alexandru Ionuț Chiuță, Liviu Mihai Sima, Nicoleta Doriana Secăreanu- signal generator (any of the cameras placed in stations IMGB Depot – PiataUnirii 2);- transmission line (coaxial cable between stations and 7 cable corrections,placed by one in stations IMGB – Piata Unirii 2);- output to the transmission line (at each station one Automatic VideoDistributor, switching of coaxial line was done by remote control relays).MTV4TDN hallPlatform 1CV1Platform1CV2Platform 2CV3Platform 2CV4Vestibule1CV5Vestibule2CV6EscalatorCV7MTV3 MTV2 MTV1HanddispenserA>VendingmachinesCentraldispatch3.2. PerformanceLevel of performance is as follows:Fig. 1. Closed Circuit Television (CCTV).- CCTV installations in stations have a level of quality to the limit ofacceptability for the image reproduced on local monitors;- signal transmitted on the coaxial line from inter stations is highly disturbed anddistorted on reception;- image obtained after the first cable correction is strongly influenced bydisturbance and has frequent non synchronization;- image obtained after the second cable correction is totally out ofsynchronization and contains hardly detectable content.Copyright © Editura Academiei Oamenilor de Știință din România, 2011Watermark Protected
Disturbances in The Power Supply Network of Bucharest Subway System 1273.3. Primary findingsCCTV installation on analysis indicates that the high density of electricalequipment, power supply configuration and underground tunnel signalizationof the subway system produce significant interference and electromagneticinteractions. These cause adverse effect in functioning of the CCTVinstallation.3.4. Disturbances3.4.1. Sources of disturbancesAfter measurements, data were obtained on disturbances in the areas of disposingthe CCTV equipment. Electrical influences can be classified as follows:a) electromagnetic influences;b) electrochemical influences.Electromagnetic influences can be:a1) low frequency electromagnetic influences (f 10 kHz).Low frequency electromagnetic influences may have several causes, such as:a1.1) current variation caused by the start of subway train (change in magneticfield);a1.2) voltage variation caused by the start of subway train (change in electricfield);a1.3) ohmic connections of the current paths due to treatment of neutralSubway system Line I and in the electrical company’s power supply thatfeeds the Subway power substations. Capacitive unbalance and neutraldisplacement influence the CCTV lines.It was found that the frequency spectrum of disturbances is correlated with thesystem power supply frequency and operating frequency, as well. Disturbanceintensity in the CCTV installations depends on the position of the subway in theunderground tunnel and the motors operating mode on the train wagons (electricarc on collector, current shocks and voltage variations).3.4.2. Ways of disturbance penetrationRegarding the penetration of disturbances in the CCTV facility, it was found bymeasurements; the disturbances penetrate through both coaxial signal line and theequipment (by electromagnetic influences). On the disturbance that penetrates thecoaxial line, the measurements highlight a significant increase (over 10 times) thelevel of disturbance on the Subway Line II in relation to Subway Line I. TheCopyright © Editura Academiei Oamenilor de Știință din România, 2011Watermark Protected
Page 1 and 2:
ACADEMY OF ROMANIAN SCIENTISTSA N N
Page 3 and 4:
ACADEMY OF ROMANIAN SCIENTISTSA N N
Page 5 and 6:
3FOREWORDBased on a rich scientific
Page 7 and 8:
Annals of the Academy of Romanian S
Page 9 and 10:
Page 11 and 12:
The remanufacturing of an articulat
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Influence of Vibrations and Dynamic
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Products recovery opportunities at
Page 29 and 30:
Products recovery opportunities at
Page 31 and 32:
Page 33 and 34:
Recycling and Remanufacturing -Two
Page 35 and 36:
Recycling and Remanufacturing -Two
Page 37 and 38:
Page 39 and 40:
The Study of Heavy Metal from Envir
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
mg/kg d.wThe Study of Heavy Metal f
Page 47 and 48:
ConclusionsThe Study of Heavy Metal
Page 49 and 50:
Page 51 and 52:
Analytical Evaluation of Crack Prop
Page 53 and 54:
Page 55 and 56:
Y d Notations:Analytical Evaluation
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
General Considerations Regardingthe
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Intelligent Networks, Smart Grids C
Page 73 and 74:
Page 75 and 76:
Page 77 and 78: Intelligent Networks, Smart Grids C
Page 79 and 80: Annals of the Academy of Romanian S
Page 81 and 82: Two-dimensional Modelling of Accide
Page 97 and 98: Project Indicators -Essential Facto
Page 103 and 104: ConclusionsProject Indicators -Esse
Page 107 and 108: Critical Infrastructures Protection
Page 123 and 124: Disturbances in The Power Supply Ne
Page 127: Disturbances in The Power Supply Ne
Page 145: Disturbances in The Power Supply Ne
show all

Volume 3 nr 1 / 2011 - Academia Oamenilor de Stiinta din Romania

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?