MK-MK2 Rotary clamp cylinder.. - SMC Pneumatics (Ireland)

Solid State Switch: Rail Mounting StyleD-J79CConnectorCautionPrecautions1. Confirm that the connector is appropriatelytightened. If tightened insufficiently,the waterproof performance will deteriorate.2. For how to handle a connector, refer tothe below figure.Auto Switch Internal CircuitD-J79COUT (+)BrownAuto Switch SpecificationsPLC: Programmable Logic ControllerD-J79CAuto switch modelD-J79CWiring type2-wireOutput type—Applicable load24 VDC Relay, PLCPower supply voltage—Current consumption—Load voltage24 VDC (10 to 28 VDC)Load current5 to 40 mAInternal voltage drop4 V or lessLeakage current0.8 mA or less at 24 VDCIndicator lightRed LED illuminates when ON.StandardsConforming to CE standards Lead wires — Oilproof heavy-duty vinyl cable: ø3.4, 0.2 mm 2 x 2 cores (Brown, Blue), 0.5 mNote 1) Refer to page 27 for solid state switch common specifications.Note 2) Refer to page 27 for lead wire lengths and lead wire with connector.WeightAuto switch modelLead wire length(m)0.535D-J79C135283Unit: gSwitchmain circuitDimensionsUnit: mmOUT (–)BlueHow to Insert the ConnectorTightening ringMost sensitivepositionSleeveConnectormounting holeIndicator lightTurn the connector so it faces the direction shown in thefigure, and after inserting it until the sleeve hits the autoswitch, screw on the tightening ring.(Do not screw it on using pliers or other tools.)35