TeeJet 854 Operating Manual_98-05051 R1

Using GPS Speed854 Sprayer Control! The GPS receiver must be sending theGPSGPVTG string at 9600 Baud with asampling rate of 1 Hz. It is OK if otherstrings are being sent also." Connect the GPS receiver to the 854console using a 45-20063 serial cable." Select GPS in the communication setupstep.! When the 854 console starts receivingspeed information from the GPS receiver,it uses that information for determining vehicle speed. If the 854 console losescommunication with the GPS receiver for more than 5 seconds, it revertsback to other sources of speed input.TeeJet VisiFlo color coding only: For other tips seePCommunicating With a Laptop Running Fieldware Software" Connect the laptop to the 854 console,using a 45-20063 serial cable." Select PC in the communication setupPCstep." Press thePRO key to advance to the nextstep." The GPS Speed step appears only if PC wasselected in the Communications Setupstep. Select ON to receive GPS speedthrough the laptop. Select OFF to use theregular radar or speed sensor input." Follow the instructions in the Fieldware manual to set up and run the ARMfunction. In System/System Setup /Control, select the TeeJet854.DRV driver.TeeJet VisiFlo color coding only: For other tips seePLogging information to a Laptop Running Logging Software" Connect the laptop to the 854 consoleusing a 45-20063 serial cable." Select LOG in the communication setupstep.! The LOG mode is an advanced data transfertool used with specially configured hardwaredevices only. This mode is not used in normalapplications.LOGTeeJet VisiFlo color coding only: For other tips seeP43 98-05051R1