TeeJet 854 Operating Manual_98-05051 R1

Programming Guidelines854 Sprayer ControlMake sure that all hardware components are properly installed and tested.Before starting the programming process, confirm that the console and allsensors are working properly.IMPORTANT PRELIMINARY INFORMATIONBefore beginning, review the following Programming Guidelines that control theprogramming process:! To enter the program mode, see the appropriate program section in thismanual. The master switch must be in the off position to enter any programmode.! To exit any program mode press and hold thePRO key for 3 seconds. Theinputs are stored and the computer exits the program mode. This action canbe done at any time during the program process.! To increase the value of a programmable digit, press the + key. To decreasethe value, press the key. These keys are located directly to the right of thedisplay. For some programming steps, pressing and holding the + or keychanges the programmable value rapidly. Pressing the + or key oncechanges the value by one.! Pressing and holding the key in some programming steps sets the value to“0”.! Pressing the key once in some steps resets the value to the factory defaultvalue.! Pressing thePRO key advances to the next programming step. After the lastprogramming step, the console completes the program loop and returns tothe first programming step.Due to differences in fonts, some letters on the displays shown inthis manual are not identical with the corresponding letters on thedisplay of the controller. We tried to match them as close aspossible.5 98-05051R1