Load Balancing Router User's Guide - Edimax

DHCP IP AddressRangeARP ProxyLAN Any IP SetupDHCP Client List• DHCP Server Setup - If you are already using a DHCP Server, theDHCP Server setting must be Disabled, and the existing DHCP servermust be set to provide the IP address of The Load Balancer as theDefault Gateway.• Client Lease Time – It is a finite period of time for a DHCP server leasean IP address to a client..• Client Default DNS – An IP address of the default DNS server for theclient requesting DHCP service.• Offered Range fields set the values used by the DHCP server whenallocating IP Addresses to DHCP clients. This range also determines thenumber of DHCP clients supported.• Free Entries indicates how many DHCP entries are not currentlyallocated, and still available.Enable this ONLY if the LAN port has an IP address in the same addressrange as the WAN port(s). This means that all PCs using this Gateway musthave valid fixed external (Internet) IP addresses.If enabled, enter the IP address range used on your LAN.By default is disabled. If you enable “LAN Any IP”, that means no matter whatstatic IP address hold on the client (your PC). The client has do not need tochange the IP address, even though it has different IP segment than LANsegment. It still can access Internet through NAT.This table shows the IP addresses which have been allocated by the DHCPServer function. For each address which has been allocated, the followinginformation is shown.• Name – The "hostname" of the PC. In some cases, this may not beknown.• MAC Address – The physical address (network adapter address) of thePC.• IP Address – The IP address allocated to this PC.• Type – Indicates IP address to be dynamic or static.• Status – If Dynamic, the IP address was allocated by this DHCP Server.If Sniffed, the IP address was detected by examining the LAN, rather thanallocated by the DHCP Server. In this case, the Name is usually notknown.• Time Left – The time expired since which IP address is leased.Page 11