Made-to-Order Sprockets - Tsubaki

“Taper-Lock” Style Bushings3535-5050Section A-ABPOSITION OF SCREWTO TIGHTEN BUSHINGA55˚FOR REMOVING FROM SHAFT:BUSHING HALF OF HOLE THREADED.HUB HALF OF HOLE NOT THREADED.DAGGFSOCKET HEAD CAP SCREWS60 ˚52˚FOR TIGHTENING ON SHAFT:HUB HALF OF HOLE THREADED.BUSHING HALF OF HOLE NOT THREADED.TAPER-LOCK BUSHINGS3535 THROUGH 5050LM8˚ TAPER INCLUDED ANGLEA ANSI “Taper-Lock” Style BushingsAll dimensions in inches unless otherwise stated.❖ L✛ MStd.Std.Bushing F Hex Short Hex Short WeightNumber ❉Bore Range A B D (3 Required) G Key ◆ Key Key ◆ Key (lbs.)3535 1³⁄₁₆ - 3¹⁵⁄₁₆ 5 3¹⁄₂ 4.83 ¹⁄₂ x 1¹⁄₂39° 2 1⁵⁄₁₆ 3³⁄₈ 2¹¹⁄₁₆ 114040 2⁷⁄₈ - 4⁷⁄₁₆ 5³⁄₄ 4 5.54 ⁵⁄₈ x 1³⁄₄40° 2³⁄₈ 1⁵⁄₈ 4¹⁄₈ 3³⁄₈ 174545 1¹⁵⁄₁₆ - 4¹⁵⁄₁₆ 6³⁄₈ 4¹⁄₂ 6.13³⁄₄ x 240° 2⁵⁄₈ 1¹⁵⁄₁₆ 4³⁄₄ 4¹⁄₁₆ 245050 2⁷⁄₁₆ - 5 7 5 6.72 ⁷⁄₈ x 2¹⁄₄37° 2¹³⁄₁₆ 2⁵⁄₁₆ 5¹⁄₄ 4¹³⁄₁₆ 32All bushings can be supplied in steel, stainless steel and other materials. Consult Tsubaki for more details.NOTES:❉ All bore ranges available in 1/16th inch increments.❖ Space required to tighten bushing. Also space required to loosen screws to permit removal of hub by puller.✛ Space required to remove bushing using jackscrews - no puller required.◆ Standard hex key cut to minimum usable length.SprocketsE-137