USER MANUAL - Teltonika

More documents

Recommendations

Info

number that fallsbetween 0000 and9999CHAP, PAP or nonebetween a user and a system that can be used to authenticate the userto the system.3. 3G authenticationmethodAuthentication method, that your carrier uses to authenticate newconnections. (This selection is unavailable on the alternate model)4. Username “user” Your username and password that you would use to connect to your5. Password “passwd”carriers network. These field become available when you select anauthentication method (i.e. authentication method is not “none”).These fields are always enabled on the alternate model.6. Preferred network GSM, UMTS orauto.Alternate model:2G, 3G or none.Your network preference. If your local mobile network supports bothGSM (2G) and UMTS (3G) you can specify to which network you wish toconnect. E.g.: if you choose GSM (2G), the router will connect to a GSM(2G) network, so long as it is available, otherwise it will connect to aUMTS (3G) network. If you select auto, then the router will connect tothe network that provides better connectivity.Warning: If an invalid PIN number was entered (i.e. the entered PIN does not match the one that was used to protectthe SIM card), your SIM card will get blocked. To avoid such mishaps it is highly advised to use an unprotected SIM. Ifyou happen to insert a protected SIM and the PIN number is incorrect, your card won’t get blocked immediately,although after a couple of reboots OR configuration saves it will.WanWAN configuration is, arguably, the crux of the routers configuration as it determines how the router will connect to theinternet. Here is quick rundown of how the page looks and what each field means.Operation ModeFirst and foremost a mode of connection has to be defined. Available selections:Type Description1. Wired An Ethernet cable connected to the WAN port of the router.2. Wifi The router will be able to connect to a local wireless access point and reach the internet through it.3. 3G The router will connect to your local mobile network for 3G access.Common configurationCommon configuration allows you to configure your TCP/IP settings for the wan network.30
You can switch between the Static, DHCP or PPPoE protocol by selecting the protocol that you want to use and thenpressing Switch Protocol31
Page 1 and 2: 1USER MANUAL
Page 3 and 4: Table of ContentsLegal notice .....
Page 5 and 6: SAFETY INFORMATIONIn this document
Page 7 and 8: IntroductionThank you for purchasin
Page 10 and 11: Setting up your routerInstallationA
Page 12 and 13: Start -> Settings -> Network Connec
Page 14 and 15: 6. By default the router is going t
Page 16 and 17: Enter the default password, which i
Page 18 and 19: Function explanationsThe following
Page 20 and 21: Field Name Sample Value Explanation
Page 22 and 23: 8. Country LT Country code.Addition
Page 24 and 25: This tri-graph illustrates average
Page 26 and 27: WAN(x)Graphs the amount of traffic
Page 28 and 29: This graph shows a concise history
Page 32 and 33: GeneralThis area is dedicated for p
Page 34 and 35: address (i.e. that IP will only wor
Page 36 and 37: Should you be asked enter the secre
Page 38 and 39: 4. DHCP-Options 6,192.168.2.1,192.1
Page 40 and 41: SecurityEncryption - There are many
Page 42 and 43: amount of failed or passed health c
Page 44 and 45: DMZBy enabling DMZ for a specific i
Page 46 and 47: 192.168.55.240 255.255.255.240 Appl
Page 48 and 49: Field name Description Notes1. Enab
Page 50 and 51: Field name Description1. Enable Ena
Page 52 and 53: Field name Explanation1. Enabled Sw
Page 54 and 55: Phase 1 and Phase 2 must be configu
Page 56 and 57: SystemsConfiguration WizardThe conf
Page 58 and 59: The final step allows you to config
Page 60 and 61: Important notes:Leaving “Keep set

USER MANUAL - Teltonika

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?