contents - Utax

Setting your machineTECHNICAL PARAMETERSAs delivered your fax is preset by default. However, you may adjust it to meet your requirements byresetting the technical parameters.To set the technical parameters:29 OK - SETUP / TECHNICALS Select the desired parameter and confirm with OK. With the keys or , modify the parameter settings by following the table below andpress OK.Parameter Setting Signification1 - SCANNINGMODE1 - NORMAL2 - FINE3 - SFINE4 - PHOTODefault value of the scan mode resolution for the documentsto be transmitted.2 - TX HEADER 1 - WITH2 - WITHOUT3 - TX SPEED 1 - 336002 - 144003 - 120004 - 96005 - 72006 - 48007 - 24004 - ECHO PROTECT 1 - WITH2 - WITHOUT6 - EPT MODE 1 - WITH2 - WITHOUT7 - COM. DISPLAY 1 - SPEED2 - PAGE NUMBER8 - ECO ENERGY 1 - WITHOUT2 - DELAY 5 MIN3 - DELAY 15 MIN4 - DELAY 30 MIN5 - STDBY PERIOD10 - RX HEADER 1 - WITH2 - WITHOUTIf this parameter is on, your header will appear on alldocuments sent to your subscribers with your name, number,date and number of pages.Warning: If you send a fax from the document loader, thetransmission header will not appear on the document yourcorrespondent receives.Transmission speed for outgoing documents.For a quality telephone line (compatible, no echo),communications occur at maximum speed.However, it may be necessary to restrict the transmissionspeed for some calls.If this parameter is on, the on-line echo will be reduced duringlong distance calls.For some long distance calls (satellite), the on-line echo maydisturb the call.Choice between transmission speed displayed or number ofthe page in progress.Choosing the printer standby delay: the printer will switch tostandby after a delay (in minutes) of NON-operation or duringthe period of time of your choice.If this parameter is on, all documents received by your faxwill include the subscriber’s header with his name, number (ifavailable) fax print date and the page number.3-8