User's Manual SiteView – Data Logger Software

Calibrate:Click to start on-line/off-line calibration of a channel:GeneralThis sub tab page displays the general properties of the logger.LED Light When Sampling:If this check box is checked the on-board LED is enabled.Description:This field specifies the description of the logger. The maximum characters for this field is 30.Sampling Interval:This field specifies the current sampling interval of the logger. Sampling interval is the timedelay between two samples the logger is taking. Most Site-Log loggers have the interval from20 milliseconds to 12 hours.Start Time:This field specifies the time when the logger took the first sample or in FIFO mode, the earliestsample time.End Time:This field specifies the time when the logger took the last sample. If the logger is stilloperating, the time refers to the last sample time before SiteView contacted the logger.Logging Method:This field specifies if the logger will continue recording data (FIFO) or stop recording datawhen the memory is full.Total Memory:This field specifies the total available on-board memory for logging.User Selected Memory:This field specifies the memory size that user have selected for logging. If the total memory iscapable of logging for one year but you only need one month of data, you may select onemonth as the logging time span and. In this case the User Selected Memory will be smallerthan the Total Memory and you always get one month of data from the logger.The logger was last configured at:This field specifies the last time when it was configured.SiteView User’s Manual – Microedge Instruments Inc. 129/200