User's Manual SiteView – Data Logger Software

V1W0W1W2X0X1X2X3X4Y0Y1Result codes will be sent in work form. (See the result code table.)Report DTE speed only. After connection, there will be no message about whatError Correction or Data Compression protocol is in use.Report DCE speed, Error Correction/Data Compression protocol, and DTE speedReport DCE speed onlySend OK, CONNECT, RING, NO CARRIER, ERROR and NO ANSWER. Busy anddial tone detection are disabled.Send X0 messages and CONNECT speedSend X1 messages and NO DIAL TONE.Send X2 messages and BUSY and RING BACK. Dial tone detection is disabled.Send all responses.Disable long space disconnect.Enable long space disconnect; with error correction, hang up after sending 1.6 secondlong space; without error correction, hang up after 4 second long space.Z0 Reset modem to profile 0Z1 Reset modem to profile 1+++This is the default escape sequence. Transfers the modem from data mode to commandmode. Must be preceded by at least 1 second of no characters and followed by onesecond of no characters. O0 (ATO0 or ATO) returns the modem to data mode.=n Sets the value of the default S register.&&C0&C1&D0&D1&D2&D3&F&K0&K3&K4&K5&K6&P0&P1&P2Ampersand commandsForce data carrier detect (DCD) onDCD follows remote carrierDTR is assumed onDTR drop causes modem to go back to command mode without disconnectingDTR drop causes modem to hang upDTR drop causes modem to initialize; &Y determines which profile is loaded.Load factory profileDisable flow controlEnable RTS/CTS flow controlEnable XON/XOFF flow controlEnable transparent software flow controlEnable both RTS/CTS and XON/XOFF flow controlSelects 33%-67% make/break ratio at 10 pulses per second.Selects 33%-67% make/break ration at 20 pulses per secondSelects 33%-61% make/break ration at 10 pulses per secondSiteView User’s Manual – Microedge Instruments Inc. 196/200