User's Manual SiteView – Data Logger Software

Reg. 6Reg. 7Reg. 8Reg. 9Reg. 10Reg. 11Reg. 12Reg. 13Reg. 14Reg. 15Reg. 16Reg. 17Reg. 18Reg. 19Reg. 20Reg. 21Reg. 22Reg. 23Reg. 24Reg. 25Reg. 26Reg. 27Reg. 28Reg. 308 (backspace)Wait before dialing. Sets the length of time to pause after off-hook before dial. Range is2-255 seconds. Default is 2 seconds.Wait for carrier after dialing. Sets the length of time that the modem waits for a carrierfrom the remote modem before hanging up. Range is 1-255 seconds. Default is 50seconds.Pause time for dial delay. Sets the length of time to pause for the pause dial modifier ",".Range is 0-255 seconds. Default is 2 seconds.Carrier detect response time. Defines the length of time a signal is detected and qualifiedas a carrier. Range is 1-255 tenths of a second. Default is 6 (0.6 seconds)Lost carrier hang up delay. Sets the length of time the modem waits before hanging upfor a carrier loss. Range is 1-255 tenths of a seconds. Default is 14 (6 seconds ????)DTMF speed control. Sets the length of tone and the time between tones for the tonedialing. Range is 50-255 milliseconds. Default is 95 milliseconds.Escape Prompt Delay (EPD) timer. Sets the time from detection of the last character ofthe three character escape sequence until the "K" is returned to the DTE. Range is 0-255fiftieths of a second. Default is 50 (1 second)ReservedReservedReservedReservedReservedTest timer. Sets the length of loopback test. Range is 0-255 seconds. Default is 0(disable timer)ReservedReservedReservedReservedReservedReservedDelay to DTR. Sets the length of time the modem ignores DTR before hanging up.Range is 0-255 hundredths of a seconds. Dafault is 5 (0.05 seconds)ReservedReservedReservedDisconnect inactivity timer. Sets the length of time allowed for inactivity before theconnection is hung up. Range is 0-255 in minutes. Default is 0 (disabled)Reg. 32 XON character. Sets the value of XON character. Range is 0-255. Default is 17SiteView User’s Manual – Microedge Instruments Inc. 199/200