User's Manual SiteView – Data Logger Software

E1H0H1I0I1I2I3I4L0L1L2L3M0M1M2M3N0N1O0O1PQ0Q1SnSn=mSn?TV0Commands are echoed to the local terminal.Force modem on-hook (hang-up)Force modem off-hook (to answer or dial).Return numeric product codeReturn hardware variation codeReport internal codeReport software revision numberReport product feature listingSpeaker volume zeroSpeaker volume lowSpeaker volume lowSpeaker volume low (Hardware currently limits volume adjustment to on/off)Speaker always offSpeaker on until carrier detectedSpeaker always onSpeaker on during answering onlyDisable auto-mode. This forces the modem to connect at the speed specified in registerS37Enable auto-mode. The modem will answer at the highest available line speed andignore any ATBn command.Return to data mode. If you have entered the command mode using the time independentescape sequence, this will put you back in data mode without going on-hook.Retrain the modem. If the line condition has changed since the original connection,retraining the modem will cause it to reconnect at the most efficient speed for the currentline condition.Pulse dialing allows the modem to work on telephone networks where one is notsupported. Pulse and tone dialing cannot be mixed on the same command line.Enable response to DTE.Disable response to DTE. The modem does not respond to the terminal. Issuing acommand will not produce a response (unless the command is something like ATZ,which will restore this setting to default).Set default S-register. Any subsequent = or ? commands will modify the default Sregister.Set register n to value mReturn the value of register nTone dialing - Pulse and tone dialing can not be mixed on the same command line.Result codes will be sent in numeric form. (See the result code table)SiteView User’s Manual – Microedge Instruments Inc. 195/200