User's Manual SiteView – Data Logger Software

The above page shows all parameters you have input as well as the values the system havecalculated. Two important values can be saved back to the logger by clicking SaveParameters to the logger. Those two parameters are: Calibration Low Value andCalibration High Value.If you click Save Parameters to the logger button you will get the below warning dialog.Click Yes to confirm the saving process.If the system saved the parameters back to the logger successfully, at the bottom side of thedialog The calibration is finished! will appear.You may click Done button to close the dialog.SiteView User’s Manual – Microedge Instruments Inc. 59/200