12.07.2015 Views

Read all instructions in this manual and component part - Jayco

Read all instructions in this manual and component part - Jayco

Read all instructions in this manual and component part - Jayco

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Sett<strong>in</strong>g Up Camp...Caution: After the slideout is extended, verify that the cornersof the black rubber seal are set up correctly. The corners of <strong>this</strong>seal are cut at a 45 degree angle. The top of the seal mustoverlap the side of the seal to avoid the possibility of waterpenetration. Fig. 6Extend<strong>in</strong>g Room1. The batteries must be fully charged <strong>and</strong> connected. Thetravel trailer should be hooked up to 120-volt AC power <strong>and</strong>have the power converter operat<strong>in</strong>g, if possible.2. The travel trailer must be level <strong>and</strong> the stabilizer jacks <strong>in</strong> thedown position.Caution: Additional support jacks are not needed under theslideout. Damage can occur to your slideout room from improperuse of support jacks.3. Locate the slideout room control switch (Fig. 7).4. To move the room out, press the “OUT” section of the switch<strong>and</strong> hold it until the motor stops. Operat<strong>in</strong>g the switch after theroom is fully extended will damage the switch <strong>and</strong> motor.Travel time - approximately twenty-five seconds.Fig. 6Fig. 7Retract<strong>in</strong>g Room1. Remove <strong>all</strong> objects left between the slideout <strong>and</strong> cab<strong>in</strong>etry.2. Press the “IN” section of the switch <strong>and</strong> hold it until the motor stops. Operat<strong>in</strong>g theswitch after the room is fully retracted will damage the switch <strong>and</strong> motor.SOFA SLIDEOUT (CERTAIN MODELS)Fig. 8Extend<strong>in</strong>g Room1. The batteries must be fully charged <strong>and</strong> connected. The trailer should be hooked up to120-volt AC power <strong>and</strong> have the power converter operat<strong>in</strong>g, if possible.2. The trailer must be level <strong>and</strong> the stabilizer jacks <strong>in</strong> the down position.Caution: Additional support jacks are not needed under the slideout. Damage canoccur to your slideout room from improper use of support jacks.3. Remove the travel bars from beh<strong>in</strong>d the top facia board located above the slideout.(Fig. 8)4. Locate the slideout control switch. (Fig. 7)5. To move the room out, press the “OUT” section of the switch <strong>and</strong> hold it until themotor stops. Operat<strong>in</strong>g the switch after the room is fully extended will damage theswitch <strong>and</strong> motor. Travel time – approximately twenty-five seconds.42 Jay Flight Conventional Travel Trailer <strong>and</strong> Fifth-Wheel Travel Trailer

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!