12.07.2015 Views

Read all instructions in this manual and component part - Jayco

Read all instructions in this manual and component part - Jayco

Read all instructions in this manual and component part - Jayco

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Sett<strong>in</strong>g Up Camp...WaterA complete fresh water system is <strong>in</strong>cluded <strong>in</strong> your RV. Fresh water is supplied to thesystem from two sources:• City fill connection hooked to an exterior water source.• A gravity fill tank <strong>in</strong>st<strong>all</strong>ed on the trailer.TO UTILIZE THE CITY WATER CONNECTION1. Attach a fresh water hose from the city water connection(Fig. 10) to the campground water source.2. When the water is turned on, you may experience some air <strong>in</strong>the water l<strong>in</strong>es. Make sure to let <strong>all</strong> <strong>this</strong> air escape beforeturn<strong>in</strong>g off the faucet.Caution: The h<strong>and</strong>le should be <strong>in</strong> the tank water position whenconnect<strong>in</strong>g the city water to avoid a city water spill.TO UTILIZE THE INSTALLED TANKGravity Fill Tank1. Remove the cap from the gravity fill connection. (Fig. 111)2. From an exterior water source, <strong>in</strong>sert the fresh water hose <strong>in</strong>tothe gravity fill connection.3. Fill the tank as desired. The size of the tank will vary based onyour unit’s floor plan. It is also equipped with an overflowoutlet. Make sure that you do not leave the tank unattendedwhile fill<strong>in</strong>g it. Do not overfill the tank.Fig. 10Fig. 111Caution: Be careful not to overfill the tank. It can pressurize the tank, caus<strong>in</strong>gleakage <strong>and</strong> water damage <strong>and</strong> void the warranty. DO NOT leave the tankunattended while fill<strong>in</strong>g.12 VOLT DC ON-DEMAND WATER PUMPTo extract water from your water tank, you need 12 volt DC power to operate theon-dem<strong>and</strong> water pump. Energy for the pump is supplied by the auxiliary battery orconverter. Depend<strong>in</strong>g on your trailer model, the pump will be located under the bed, <strong>in</strong> acupboard, under the unit or under the s<strong>in</strong>k. The switch to operate the pump is located on themonitor panel or a w<strong>all</strong> near the pump.Refer to <strong><strong>in</strong>structions</strong> supplied by the pump manufacturer with your trailer. If you havequestions, consult with your <strong>in</strong>dependent, authorized dealer <strong>and</strong>/or visit the manufacturer’swebsite at www.shurflo.com.NOTE: The water pump switch should be <strong>in</strong> the off position when the camper is leftunattended for any amount of time. If someth<strong>in</strong>g would happen to the water system,<strong>this</strong> will help limit water damage to a sm<strong>all</strong>er area.Jay Flight Conventional Travel Trailer <strong>and</strong> Fifth-Wheel Travel Trailer 45

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!