Read all instructions in this manual and component part - Jayco
Read all instructions in this manual and component part - Jayco
Read all instructions in this manual and component part - Jayco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Ma<strong>in</strong>ta<strong>in</strong><strong>in</strong>g Your Investment...Troubleshoot<strong>in</strong>g the Electric Slideout• If the slideout does not move when the slideout switch is depressed, follow thesesteps. Check the battery for a full charge <strong>and</strong> good wire connections. Check for loose connections at the slideout motor.• If the slideout still will not operate, follow these steps. If the slideout is extended, see the section on overrid<strong>in</strong>g the electric slideout system. If the slideout is retracted, leave it <strong>in</strong> that position. Take the trailer to a <strong>in</strong>dependent, authorized dealer or service center.• If the slideout extends crooked, or only one side moves, follow these steps. Follow steps on overrid<strong>in</strong>g the slideout system. You may need to push the side that is not slid<strong>in</strong>g to get it to retract <strong>all</strong> the way. Take your trailer to an <strong>in</strong>dependent, authorized dealer or service center.Tools required• ScruLox head screwdriver (if trailer has anunderbelly)• 1/2" wrench• Adjustable wrench or ratchet <strong>and</strong> 3/4 socket.MAIN ROOM SLIDEOUT OVERRIDE1. If the trailer has an underbelly, locate <strong>and</strong>remove the access panel for the slideoutmotor. This panel is typic<strong>all</strong>y on the oppositeside of the trailer from the slideout room.2. Use a 3/4 socket <strong>and</strong> ratchet on the hex headlocated on the end of the drive shaft <strong>and</strong> turnthe shaft until the slideout is <strong>in</strong> the position you desire.Fig. 35SOFA SLIDEOUT OVERRIDE1. Inside the trailer, lift the sofa skirt to access theslideout motor.2. Locate the hex head screw on the front of the motor.Us<strong>in</strong>g a ratchet <strong>and</strong> 3/4" socket, turn the screwcounter-clockwise to retract the slideout.3. Inst<strong>all</strong> the travel bars <strong>in</strong> the proper locations as<strong>in</strong>dicated on the w<strong>all</strong>.4. Take your trailer to an <strong>in</strong>dependent, authorized dealeror service center.Fig. 36TV ANTENNAMa<strong>in</strong>tenance <strong>in</strong>formation for your TV antenna is supplied with your trailer from themanufacturer. Refer to <strong>this</strong> <strong>in</strong>formation for complete <strong><strong>in</strong>structions</strong> <strong>and</strong>/or consult with your<strong>in</strong>dependent, authorized dealer. Information can also be found at the manufacturer’swebsite at www.w<strong>in</strong>gard.com.86 Jay Flight Conventional Travel Trailer <strong>and</strong> Fifth-Wheel Travel Trailer
Change language