Read all instructions in this manual and component part - Jayco

Setting Up Camp...Retracting Room1. Remove all objects left between the slideout and cabinetry.2. Press the “IN” section of the switch and hold it until the motor stops. (Fig. 7)Operating the switch after the room is fully retracted will damage the switch andmotor.3. Install the travel bars in the proper locations as indicated on the wall. (Fig. 8)Caution: IMPORTANT! Never store slideout without the travel bars installed. Thishelps seal the slideout in the closed position.BOOTH DINETTE TO BED CONVERSION1. Remove the table top and cushions. Place them to the side.2. Remove the table legs from the floor brackets and place them in one of the storagecompartments of the dinette seats. Place the storage cover back on the dinette seat.3. Place the table top across the middle from one dinette seat to the other resting on thefront edge bracket. For comfort, make sure the table top is level with the top of thedinette bench.4. Position the dinette bench cushions in place across the benches and the table top.To convert back to the booth dinette, reverse the procedures above.Extendable Dinette (Certain Models Only)Your trailer may be equipped with extensions on thedinette benches that can be used only when theslideout is extended. To extend the dinette benches:1. Remove the snap strap securing the dinettebench in the travel position.2. Pull on the end of the dinette bench until it hitsthe stops.3. Remove the seat and back cushions from thestorage compartment and place them to theside.4. Remove the plywood seat extension fromstorage and place it across the brackets of theextension drawer. This plywood must be inFig. 9place to use the dinette extension. (Fig. 9)5. Place the seat and back cushions on the extensions.6. Repeat the process for the other dinette bench.To close the extendable dinette, reverse the above procedures. The extendable dinette mustbe closed, secured with the snap strap and the table left in the bed position before theslideout is brought into the travel position.J- STEEL SOFA TO BED CONVERSION1. Lift up on the sofa seat and pull toward the center of the unit.2. As you pull up, the back of the sofa will fall down and lay out flat to create a bed.3. To convert back into a sofa, again lift up on the front edge and push toward the unitwall.4. As you do this, the sofa back will lift into an upright position.locking the plug into the socket. (Fig. 3)Jay Flight Conventional Travel Trailer and Fifth-Wheel Travel Trailer 43