Assembly Instructions - Swing-N-Slide

Assembly InstructionsFig. 96-1/2'' Carriage BoltsFor Swing Hangers(4)1-1/4'' Screwsper Beam ClampBeam ClampWasherLoc-Nut1-1/4'' ScrewSwing Beam Hardware1. Center beam clamps over the holes on the Same Side of the Swing Beam You Drilled Your Holesand attach using four 1-1/4" screws per beam clamp as shown in (Fig. 9).2. Insert carriage bolt through the beam clamp and beam. Tapping the bolts through the beam with ahammer may be required.NOTE: The square base of the carriage bolt must seat into the square hole of the beam clamp.3. Place swing hanger over the protruding bolts on the underside of the beam and attach using two washersand loc nuts per swing hanger. Tighten loc nuts securely.4. Place accessory chains over the quick link and tighten with wrench until secure.Note: When attaching Quick Link, make certain threads are pointing up. This will help keep the Quick Linkfrom loosening over time.5. Repeat for all four hangers.17