airOS v5.5.4 User Guide - Ubiquiti Networks

airOS v5.5.4 User Guide• airMAX Capacity This is an index of the maximum datarate the link is operating at. A lower capacity numberindicates a unit that is slowing down the system.• Last IP Displays the station’s last IP address.• TX/RX Rate Displays the data rates, in Mbps, of the lasttransmitted and received packets.• TX/RX Bit Rate Displays the data rates, in bps, of thelast transmitted and received packets.• TX/RX Packets Displays the total number of packetstransmitted and received from the station during theconnection uptime.• TX/RX Packet Rate, pps Displays the mean value of thetransmitted and received packet rates.• Bytes Transmitted Displays the total amount of data(in bytes) transmitted during the connection.• Bytes Received Displays the total amount of data (inbytes) received during the connection.• Negotiated Rate/Last Signal, dBm Values representthe received wireless signal level along with the datarates of recently received packets. N/A is displayed as theLast Signal if no packets were received on that specificdata rate.• Kick To drop the connection to the station, click Kick.• Refresh To update the information, click Refresh.• Close To close the Station Info window, click Close.AP Information(Available in Station mode only.) This selection lists theconnection statistics of the AP associated with the device.Chapter 3: Main TabConnection Time Displays the amount of time the devicehas been connected to the AP. The time is expressed indays, hours, minutes, and seconds.Signal Strength The value represents, in dBm, the lastreceived wireless signal level.Noise Floor Displays the current value (in dBm) of theenvironmental noise (from interference) the receiver hearson the operating frequency. airOS considers the NoiseFloor while evaluating the signal quality (Signal-to-NoiseRatio SNR, RSSI). The value mean depends on the signalstrength above the Noise Floor.CCQ The value represents the quality of the connection tothe AP. This index evaluates the wireless Client ConnectionQuality (CCQ). The level is a percentage value for which100% corresponds to a perfect link state.Last IP Displays the device’s last IP address.TX/RX Rate Displays the data rates, in Mbps, of the lasttransmitted and received packets.TX/RX Bit Rate Displays the data rates, in bps, of the lasttransmitted and received packets.TX/RX Packets Displays the total number of packetstransmitted and received from the station during theconnection uptime.TX/RX Packet Rate, pps Displays the mean value of thetransmitted and received packet rates.Bytes Transmitted Displays the total amount of data (inbytes) transmitted during the connection.Bytes Received Displays the total amount of data (inbytes) received during the connection.Negotiated Rate/Last Signal, dBm Values represent thereceived wireless signal level along with the data ratesof recently received packets. N/A is displayed as the LastSignal if no packets were received on that specific datarate.Reconnect To establish the wireless link to the AP again,click Reconnect.Refresh To update the information, click Refresh.InterfacesDisplays the name, MAC address, MTU, IP address, andtraffic information for the device’s interfaces.Access Point Displays the MAC address of the AP.Device Name Displays the host name of the AP.Product Displays the product name of the device.Firmware Displays the firmware version of airOS.Ubiquiti Networks, Inc.Interface Displays the name of the interface.MAC Address Displays the MAC address of the interface.MTU Displays the Maximum Transmission Unit (MTU),which is the maximum packet size (in bytes) that anetwork interface can transmit. The default is 1500.IP Address Displays the IP address of the interface.14