airOS v5.5.4 User Guide - Ubiquiti Networks

airOS v5.5.4 User GuideSpeed TestThis utility allows you to test the connection speedbetween two airOS devices that are using firmwareversion 5.2 or above. You can use Speed Test to estimate apreliminary throughput between two network devices.Note: If traffic shaping is enabled on eitherdevice, then the Speed Test results will be limitedaccordingly.Chapter 9: ToolsTest Results Displays three result categories:• RX Displays the estimated incoming throughput.• TX Displays the estimated outgoing throughput.• Total Displays the aggregate throughput.airViewUse the airView Spectrum Analyzer to analyze the noiseenvironment of the radio spectrum and intelligently selectthe optimal frequency to install a PtP airMAX link.There are two system requirements for the airViewSpectrum Analyzer:• Your system is connected to the device via Ethernet.Launching airView will terminate all wirelessconnections on the device.• Java Runtime Environment 1.6 (or above) is required onyour client machine to use airView.On first use, the following window appears.Select Destination IP You have two options:• Select a remote system IP from the drop-down list,which is generated automatically.• Select specify manually and enter the IP address in thefield displayed below.User Enter the administrator username.Note: Enter the remote system access credentialsrequired for communication between two airOSdevices. Administrator username and password arerequired to establish the TCP/IP-based throughputtest.Password Enter the administrator password.Remote WEB port Enter the remote web port of theairOS device to establish a TCP/IP-based throughput test(for example, specify port 443 if HTTPS is enabled in theremote device). If the web port of the remote device is notcorrect, then the ICMP throughput measurement routinewill be initiated.Show Advanced Options Enables additional Speed Testutility options.Direction Select one of three directions:• duplex Estimates the incoming (RX) and outgoing (TX)throughput at the same time.• receive Estimates the incoming (RX) throughput.• transmit Estimates the outgoing (TX) throughput.Run Test Click this button to start the test.• Do NOT warn me about this in the future Check thebox to bypass this window in future launches of theairView Spectrum Analyzer.• Launch airView Click Launch airView to download theJava Network Launch Protocol (jnlp) file and completethe launch of airView.Ubiquiti Networks, Inc.61