ARM DS-5 Using the Debug Hardware Configuration Utilities

Configuring network settings for your debug hardware unit3.3 The Configure Debug Hardware unit dialog boxThe Configure Debug Hardware unit dialog box enables you to modify the network settings ona debug hardware unit that has previously been configured. The following figure shows anexample:Figure 3-1 The Configure Debug Hardware unit dialog boxNoteYou can modify the settings only for a debug hardware unit that is on your local network or thatis connected to a USB port on your PC.The network settings available depend on whether or not your network uses Dynamic HostConfiguration Protocol (DHCP):• If your network uses DHCP, you must know:— the hostname that you want to use for your unit (if any)— the Ethernet type of your network.• If your network does not use DHCP, you must know:— the hostname that you want to use for your unit (if any)— the IP address that you want to use for your unit— the default gateway for your network (if it has one)— the subnet mask for your network.— the Ethernet type of your network.NoteThe Ethernet Address field is read-only.After setting up the network settings, click Configure to write the values to the unit.Click Exit to close the Configure Debug Hardware unit dialog box3.3.1 See alsoTasks• About configuring network settings on page 3-2• Determining the correct network settings on page 3-3• Configuring the network settings for a debug hardware unit on page 3-8• Modifying the network settings for a debug hardware unit on page 3-10• Troubleshooting on page 3-13.ARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 3-4ID021112Non-Confidential