ARM DS-5 Using the Debug Hardware Configuration Utilities

Configuring network settings for your debug hardware unit3.4 The Configure new Debug Hardware unit dialog boxThe Configure new Debug Hardware unit dialog box enables you to:• configure the network settings for a debug hardware unit that has not been previouslyconfigured• configure the network settings for a debug hardware unit that is on a different subnet.The following figure shows an example:Figure 3-2 The Configure new Debug Hardware unit dialog boxThe network settings available depend on whether or not your network uses Dynamic HostConfiguration Protocol (DHCP):• If your network uses DHCP, you must know:— the hostname that you want to use for your unit (if any)— the Ethernet address of unit— the Ethernet type of your network.• If your network does not use DHCP, you must know:— the hostname that you want to use for your unit (if any)— the IP address that you want to use for your unit— the default gateway for your network (if it has one)— the subnet mask for your network.— the Ethernet address of unit— the Ethernet type of your network.If more than one unit is listed in the browser, click Identify to identify your unit. TheIdentification LEDs on the selected unit flash for five seconds.After setting up the network settings, click Configure to write the values to the unit.Click Exit to close the Configure new Debug Hardware unit dialog box3.4.1 See alsoTasks• About configuring network settings on page 3-2• Determining the correct network settings on page 3-3• Configuring the network settings for a debug hardware unit on page 3-8.Reference• Debug hardware unit network settings on page 3-7.ARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 3-6ID021112Non-Confidential