Banner Web Tailor / User Guide / 8.3 - Parent Directory

TWGBPARM_PARAM_NAMELDAPL4FLAGLDAPL4FLTRLDAPPWDLENGTHLDAPMAPUSERMAXSEARCHRESULTSTWGBPARM_PARAM_VALUE(Example/Description)For authenticated searches against a Luminis IV LDAPserver. Set the value to Y to enable login to SSB usingLDAP authentication with Luminis IV.Leave the default value of N if you are not using LDAPwith Luminis IV.For more information, see “LDAP authenticated searchin Luminis IV” on page 5-9.For authenticated searches against a Luminis IV LDAPserver. This parameter’s value indicates the prefix usedfor searching LDAP. The default value is pdsLoginId.For more information, see “LDAP authenticated searchin Luminis IV” on page 5-9.Specifies the length of the LDAP password.Note: You will use this parameter only if you are usingLDAP to authenticate user credentials.Specifies where LDAP mapping is defined. Thisparameter will be used by other products andtwbklogn.p_ValidatePin to see where to look forLDAP mapping. Valid values are:DEFAULT - The SPRIDEN ID is the same as the LDAPIDEXTERNALUSER - Treat the LDAP user as an externaluser defined in GOBTPACLDAPUSER - Treat the LDAP user as an LDAP userdefined in GOBTPACPROMPT - Prompt each LDAP user for IDNote: You will use this parameter only if you are usingLDAP to authenticate user credentials.The maximum number of results returned when a userperforms a keyword search.Example: 10January 2010 Banner Web Tailor 8.3 3-25User GuideUsing Web Tailor