SIMOVERT Master Drives Communication Board CBD

Master DrivesCBD05/20/994 Data transfer via DeviceNet4.2 Parameter area (PKW)4.2.1 Use of PKW object4.2.1.4 Parameter ID (PKE)Error numbers for the response ‘task cannot be executed’ (drive parameters). The error numbers are transferred in thePWE1 word of the response.No.Significance0 Illegal parameter No. (PNU) If the PNU does not exist1 Parameter value cannot be changed If the parameter is a visualization parameter2 Upper or lower limit exceeded −3 Erroneous sub-index −4 No array For tasks for indexed parameters to a non-indexedparameter.5 Incorrect data type −6 Setting not allowed (can only be reset) −e. g. task: ‘Change parameter value (word, array)’ fornon-indexed parameter7 Descriptive element cannot be changed Task not possible for Master Drives11 No operator control rights −12 Key word missing Drive parameter: ‘Access key’ and/or ‘specialparameter access’ not correctly set15 No text array available −17 Task cannot be executed as a result of theoperating status101 Parameter No. presently de-activated -Drive status doesn’t permit the presently issued task102 Channel width too low Parameter response too long for telegram103 Incorrect PKW No. Index response from base unit did not match indexrequested104 Parameter value not admissible -105 Parameter is indexed For tasks for non-indexed parameters to an indexedparameter.106 Task is not implemented -Comment to error number 102:e. g. task: ‘PWE, change word’ for indexed parameterThis error number is transferred, if the parameter response to a parameter task is longer than the available 6 bytes ofthe response telegram, and therefore cannot be transferred.The data is not distributed over several data telegrams.22 Siemens AG 477 759 4070 76 J AA-74SIMOVERTMASTERDRIVES Betriebsanleitung/OperatingInstructions