SIMOVERT Master Drives Communication Board CBD

More documents

Recommendations

Info

Master DrivesCBD05/20/996 Troubleshooting6.2 Diagnostics6.2.1 Diagnostic LEDs6.2 Diagnostics6.2.1 Diagnostic LEDsCBD has three LEDs for fasttroubleshooting. Confusion is eliminateddue to the different colored LEDs.NOTEAdapterBoardIf an LED is in a steady state condition(dark or bright) then this signifies thatthe unit is in a non-standard operatingstatus (parameterizing phase orfault/error)!At least one LED must flash (otherwise:Voltage OFF or CBD defective)!LED'sGreenYellowRedLED IndicatorsGreen: Telegram data transfer ok.Red: CBD ok.Yellow: Communications with TB/CU ok.V+CAN+ShieldCAN-V-.5.4.3.2.1X438CBDFig. 6.1Siemens AG 477 759 4070 76 J AA-74 59SIMOVERTMASTERDRIVES Betriebsanleitung/OperatingInstructions
Master DrivesCBD05/20/996 Troubleshooting6.2 Diagnostics6.2.1 Diagnostic LEDsStandard LED image for net data transfer via the DeviceNet busgreen flashing cyclic process data (PZD) transfer via the DeviceNet bus ok.red flashing CBD ok.Only flashes for PZD transfers, not PKW transfers or DeviceNetfunctions such as allocate. If the PZD update time is less thanapproximately 150 milliseconds, this green LED may not flash on forevery cycle compared with the red and yellow LEDs.yellow flashing dual port RAM interface ok. (CU/TB-Heartbeat-Counter)NOTEUnder standard operating conditions, all three LEDs are lit in the same clock cycle and for the same duration!Fault/error, CBDgreen steady light Fault/error cause:red flashing Fatal CBD faultyellow steady light (replace CBD)Parameterization by the drive (CU)green steady light CBD waits for the start of parameterizationred flashing by the drive (CU)yellow off (dark) e. g. if the CBD is not selected (P090/P091)green off (dark) CBD waits forred flashing parameterization to be completedyellow steady light by the drive (CU)Online operationgreen off (dark) No PZD data transfer via the DeviceNet busred flashing e. g. the bus connector has been withdrawn, EMC fault,interchanged connections,yellow flashing node number (P918) is not supplied with net data via theDeviceNet bus.60 Siemens AG 477 759 4070 76 J AA-74SIMOVERTMASTERDRIVES Betriebsanleitung/OperatingInstructions
Page 1 and 2:
SIMOVERT Master DrivesCommunication
Page 3:
Table of Contents5 Start-up........
Page 6 and 7:
Master DrivesCBD05/20/990 Definitio
Page 8 and 9:
Master DrivesCBD05/20/991 Product d
Page 10 and 11:
Master DrivesCBD05/20/992 Mounting
Page 12 and 13: Master DrivesCBD05/20/993 Connectin
Page 18 and 19: Master DrivesCBD05/20/994 Data tran
Page 40 and 41: Master DrivesCBD05/20/995 Start-up5
Page 58 and 59: Master DrivesCBD05/20/996 Troublesh
Page 68 and 69: Master DrivesCBD05/20/997 Appendix7
show all

SIMOVERT Master Drives Communication Board CBD

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?