SIMOVERT Master Drives Communication Board CBD

Master DrivesCBD05/20/995 Start-up5.2 Process data combination5.2.3 Other CBD-relevant parametersNOTEIf the “on” command (bit 0) is connected to the dual port RAM interface (Section 5.2.1 “Setpoint channel (masterto drive)”), then the following must be observed for safety reasons:An "OFF2" or "OFF3" command must be additionally parameterized to the terminal strip/PMU (refer to the driveInstruction Manual, Section “Control word”), as otherwise the converter cannot be powered-down with a definedcommand if the communications were to fail!♦ P692 (Response TLg OFF)Response to telegram failureUsing parameter P692 (also refer to the drive Instruction Manual, Section “Parameter list”) you can define as tohow the drive should respond to a telegram failure.For a parameter value 0 “Fault“ the drive immediately shuts down with fault F082, and the drive coasts down.With parameter value 1 “OFF3(fast stop)“, the drive executes an OFF3 command (OFF with fast stop) and thengoes into the fault statusF082.This parameter is only available from software version 1.3 (MASTER DRIVES FC and VC) and software version1.2 (MASTER DRIVES SC).Siemens AG 477 759 4070 76 J AA-74 47SIMOVERTMASTERDRIVES Betriebsanleitung/OperatingInstructions