SIMOVERT Master Drives Communication Board CBD

Master DrivesCBD05/20/994 Data transfer via DeviceNet4.3 Process data area (PZD)4.3.2 Setting the meaning of the PZD words4.3.2 Setting the meaning of the PZD wordsThe use of each process data word is set at the drive and is dependent on the actual function of the particular drive.Parameters that act as selector switches are used and are explained in detail in section 5.2. Until these selectorparameters are set, the process data will not control the drive or reflect the drive actual values.For the PZD combination, the number i of the process data (PZDi, i = 1 to 16) is entered into the combination value(refer to Section 5.2.1 “Setpoint channel (master to drive)”).NOTEThe process data combination displayed here is only valid if a technology board is not installed.When using a technology board (for example a T300 or T100), the process data combination can be taken fromthe technology board manual.Telegram:Master → drive(setpoint channel)PZD1STW1PZD receive (DeviceNet consume)PZD2HSWPZD3PZD4PZD5PZD6PZD7PZD8PZD9PZD10PZD11PZD12PZD13PZD14PZD15PZD161.word2.word3.word4.word5.word6.word7.word8.word9.word10.word11.word12.word13.word14.word15.word16.wordCombination valuesfor:16-bit process data 3001 3002 3003 3004 3005 3006 3007 3008 3009 3010 3011 3012 3013 3014 3015 301616/32 bit PZD3001 3032 3034 3006 3037 3039 3041 3043 3045(examples)3001 3032 3004 3005 3036 3038 3040 3042 3044 3016(also refer to Sec. 5.2)3001 3002 3033 3035 3007 3038 3010 3041 3013 3044 3016Siemens AG 477 759 4070 76 J AA-74 33SIMOVERTMASTERDRIVES Betriebsanleitung/OperatingInstructions