Example of installation & commissioning guide

CommissioningFU up to 630APlug-in Polyfast❑ check that greasing of functianal units clamps is effective❑ check the correct fixing of Polyfast on its base plate (4screws)❑ check the presence of the terminal covers on the apparatus❑ if necessary proceed with adjustment of the control unit❑ close the apparatus: «ON» position.■ removal❑ open the apparatus: «OFF» position❑ unscrew the 4 fastening screws of Polyfast on its base❑ extract Polyfast by means of the 2 handles, holding it horizontalin order to maintain the fastening screws in position.Disconnectable Polyfast❑ check that greasing of functianal units clamps is effective❑ check the correct fixing of Polyfast on its base plate (4screws)❑ check the presence of the terminal covers on the apparatus❑ if necessary proceed with adjustment of the control unit❑ close the apparatus: «ON» position.■ removal❑ open the apparatus: «OFF» position❑ remove the downstream terminal cover❑ disconnect power cables❑ unscrew the 4 fastening screws of Polyfast on its base❑ extract Polyfast by means of the 2 handles, holding it horizontalin order to maintain the fastening screws in position.Disconnectable mountingplate❑ check that greasing of functianal units clamps is effective❑ check the correct fixing of the moving part on its base plate(2 screws)❑ if necessary proceed with adjustment of the control unit❑ close the apparatus: «ON» position.Fixed and plug-in on mountingplate■ removal❑ open the apparatus: «OFF» position❑ disconnect the power terminal block❑ disconnect the auxiliary terminal block❑ unscrew the 2 fastening screws of the mounting plate on itsbase❑ extract the mounting plate, holding it horizontal in order tomaintain the fastening screws in position.❑ check that greasing of functianal units clamps is effective❑ if necessary open the door to proceed with adjustment of thecontrol unit❑ close the apparatus: «ON» position.■ removal of an apparatus from its base (refer to the apparatusleaflet).41OkkenSchneider Electric