Example of installation & commissioning guide

More documents

Recommendations

Info

CommissioningFU up to 630ADrawers■ racking❑ seize the drawer by the handles❑ press and hold the red release button❑ push the drawer fully home to the «connected» position❑ the racking is correct if the positioning mechanism is lockednotes:1 it is possible to go directly to the «connected» positionwhen putting the drawer into position2 the drawers equal or more than 12 modules need a moreimportant stress on racking. Curtly impart a firm motion ofwrists at full stroke.disconnected positionconnected positiontest position■ operation❑ when the drawer is in the «test» or «connected» position,actuate the apparatus rotary handles or the control devices(push-buttons, selector switches) according to the electricaldiagram❑ rotary handle on Compact or GV:- turn clockwise toward «ON» to close- turn counter-clockwise toward «OFF» to open- marks placed on the rotary handle indicate the position:white / ON: closedgreen / OFF: opentripped: fault.■ check that greasing of functianal units clamps is effective43OkkenSchneider Electric
CommissioningFU up to 630ADrawersAdjustmentsThe front face of the drawer is swivelling and gives access tothe devices adjustments.❑ introduce a tool inside the left handle, press moderately inorder to compress the leaf spring A and open the front panelusing the red release button❑ in the case of a drawer higher than 6 modules, remove thescrew on the front panel❑ open the door❑ carry out the adjustments❑ close again the gate. The spring goes back automaticallyin position.note:When the apparatus is closed, the voluntary opening of thedoor is possible if the «door closed locking» mechanism ofrotary handle has been inhibited or removed.44 Okken Schneider Electric
Page 2: OkkenContentsGeneral■ introductio
Page 5 and 6: Equipment receivingPackingGeneralPa
Page 7 and 8: Equipment receivingHandlingHandling
Page 9 and 10: Equipment receivingStoragePrecautio
Page 11 and 12: InstallationToolsTightening torque
Page 13 and 14: InstallationPreparing the siteFront
Page 15 and 16: InstallationPreparing the siteTop c
Page 17 and 18: InstallationPanelling the columnsSi
Page 19 and 20: InstallationInstalling the columnsI
Page 21 and 22: InstallationInstalling the columnsI
Page 23 and 24: InstallationElectrical connectionsL
Page 25 and 26: ConnectionConnecting the power cabl
Page 33 and 34: ConnectionGeneralConnection by KT b
Page 35 and 36: ConnectionGeneralConnection by KT b
Page 37 and 38: ConnectionFinishingFinishingedging
Page 39 and 40: CommissioningMasterpact NW, NT, Com
Page 41: CommissioningFU up to 630ADrawers
Page 45 and 46: CommissioningChecking and testingEn
Page 47: Schneider Electric Industries SASPo

Example of installation & commissioning guide

Create successful ePaper yourself

Delete template?

Save as template?