SHAKAERATOR - Operator Manual - McConnel

More documents

Recommendations

Info

Power Take Off GuardAt all times when an auxiliary implement is not in use the stub shaft guard should besecured in position.When operating auxiliary equipment the following applies:The rear section of the stub shaft guard is removed. As shown, the guard is suitable for thecentral and top mounting positions of the through drive shaft. For the lower position theguard mounting plate is inverted and the top guard assembled on secondary flange 'A'provided. Remember these guards are a legal requirement and on no account should theShakaerator be used on its own or in a combination without the relevant guards securely inposition.Illustration Note: The illustration above shows an early through drive – current machineswill have a shorter through drive shaft with a shorter spring and the rear bearing andbearing back block inboard of the through drive mounting plate.21
Turf DiscsSpring loaded turf discs are available, which are supplied as an option, when it is desiredto create a minimal surface disturbance in pastureland. The normal application is tomount the discs on the front toolbar in a position where they will slice the turfimmediately in front of the following shank.Turf discs are normally used with a roller. It is not possible to use the outermost discmounting position with wheels installed. A typical arrangement of four discs and shankson a 3m frame is shown below. Up to six discs and shanks can be used on a 4.5mframe.In some circumstances it is possible to fit a disc in the centre, but in this positionclearance beneath the frame is limited, so that the maximum working depth would bereduced.22
Page 1 and 2: Publication 437August 2003Part No.
Page 3 and 4: WARRANTY POLICYWARRANTY REGISTRATIO
Page 5 and 6: EC DECLARATION OF CONFORMITYConform
Page 7 and 8: GENERAL INFORMATIONRead this manual
Page 9 and 10: INTRODUCTIONMcConnel Shakaerators a
Page 11 and 12: Shank OptionsFixed Frame Models:•
Page 13: FITTINGTractor Power RequirementsIt
Page 16 and 17: Depth WheelsThe depth wheels, where
Page 18 and 19: General View (Standard Model)13
Page 20 and 21: Working DepthThe depth to which the
Page 22 and 23: Re-compactionLoosened soil is extre
Page 24 and 25: Shear PinsAs the roller is mechanic
Page 28 and 29: Shin GuardsShin guards can be strap
Page 30 and 31: GRASSLAND MODELSRoller HeightThe wo
Page 32 and 33: Grassland Clamp & Point Fitment - 3
Page 34 and 35: Pressurising the Hose SystemThe hos
Page 36 and 37: MAINTENANCEService and MaintenanceM

SHAKAERATOR - Operator Manual - McConnel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?