infcr-b - Newport

More documents

Recommendations

Info

8 SpecificationsALARM OUTPUTS (if applicable)2 Form "C" on/off relays. Configurable for latched and unlatched by software.Max current:5 AMPS, resistive load.Max voltage:250 V ac or 30 V dcISOLATED ANALOG OUTPUT (TB5, if applicable)Same as non-isolated analog output except isolated to 1000 Vdc.Signal Type:Current or voltageSignal Level:Current: 10 V max compliance at 20 mA outputVoltage: 20 mA max for 0-10 V outputFunction:May be assigned to a display range or proportional controloutput with setpoint #1 when used as a control output.Linearity: 0.2%Step Response Time: 2 - 3 seconds to 99% of the final valueOnly one analog output is available on each unit and it must be factory installed.40
Specifications 848,0 (1.89)96,0 (3.78)20,3 (.80)FRONT BEZEL151,4 (5.96)RETAINERCASEREAR COVERSIDE VIEWTOP VIEWPANEL THICKNESS6,4 (.25) MAX0,8 (.03) MIN1,5R (.06)4 PLCS45,00 + 0,61/-0,00(1.772 + .024/–.000)92,00 + 0,81/–0,00(3.622 + .032/–.000)NOTE: Dimensions in Millimeters (Inches)Figure 8-1. Meter Dimensions41
Page 3 and 4: PREFACEManual ObjectivesThis manual
Page 5 and 6: Table of Contents4.9 OUTPUT CONFIGU
Page 7: Table of ContentsNOTES, WARNINGS an
Page 10 and 11: 1 Introduction1.2 SAFETY CONSIDERAT
Page 12 and 13: 2 About The Meter2.3 AVAILABLE ACCE
Page 14 and 15: 2 About The Meter2.4 FRONT OF THE M
Page 16 and 17: 2 About The Meter2.5 REAR OF THE ME
Page 18 and 19: 2 About The Meter2.6 DISASSEMBLYYou
Page 20: 3 Getting Started3.2 MAIN BOARD POW
Page 24 and 25: 3 Getting Started3.5 CONNECTING MAI
Page 27 and 28: 4SECTION 4. CONFIGURING THE METERRe
Page 29 and 30: Configuring The Meter44.5 SETPOINT
Page 31 and 32: Configuring The Meter44.8 SETPOINT
Page 33 and 34: Configuring The Meter44.10 PROPORTI
Page 35 and 36: Configuring The Meter44.12 OUTPUT S
Page 37 and 38: Configuring The Meter44.13 RTD TEMP
Page 39 and 40: Configuring The Meter44.15 BRIGHTNE
Page 41 and 42: Menu Configuration6SECTION 6. MENU
Page 43 and 44: Menu Configuration6Not all menu ite
Page 45 and 46: Menu Configuration6Table 6-3. Run M
Page 47: Specifications 8ANALOG OUTPUT (if a
Page 51 and 52: CE APPROVALS INFORMATIONThis produc
Page 53 and 54: NOTES45
Page 55 and 56: Warranty/DisclaimerNEWPORT Electron

infcr-b - Newport

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?