Rotating Joints - VEX Robotics

4. Create and dimension a sketch as shown. Adda horizontal constraint between the center ofthe left arc and the left vertical edge of thesketch.10. Click Point, Center Point.11. Create a center point as shown. Dimensionthe point and then center it vertically using ahorizontal constraint.5. On the ViewCube, click Home.6. Press E to start the Extrude tool.■■■■For the profile, select inside the sketch.Under Operation, click Cut.Under Distance, select All from the list.Click OK.12. On the ViewCube, click Home.13. Press H to start the Hole tool.■For Diameter, enter 0.26.■■Under Termination, select Through Allfrom the list.Click OK.7. Click 2D Sketch.8. Select the face as shown.14. Save the file as Link.ipt.15. Close the file.9. On the ViewCube, click Front.Create Phase■17