Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide

Cursors 12• Binary — Logic levels of displayed waveforms at the current X1 andX2 cursor positions are displayed above the softkeys in binary. Thedisplay is color coded to match the color of the related channel'swaveform.• Hex — Logic levels of displayed waveforms at the current X1 and X2cursor positions are displayed above the softkeys in hexadecimal.Manual and Track Waveform modes can be used on waveforms that aredisplayed on the analog input channels (including math functions).Binary and Hex modes apply to digital signals (of MSO oscilloscopemodels).In Hex and Binary modes, a level can be displayed as 1 (higher thantrigger level), 0 (lower than trigger level), indeterminate state ( ), or X(don't care).In Binary mode, X is displayed if the channel is turned off.In Hex mode, the channel is interpreted as 0 if turned off.4 Press Source (or X1 Source, X2 Source in the Track Waveform mode); then,select the input source for cursor values.5 Select the cursor(s) to be adjusted:• Push the Cursors knob; then, turn the Cursors knob. To finalize yourselection, either push the Cursors knob again or wait about fiveseconds for the popup menu to disappear.Or:• Press the Cursors softkey; then, turn the Entry knob.The X1 X2 linked and Y1 Y2 linked selections let you adjust both cursors atthe same time, while the delta value remains the same. This can beuseful, for example, for checking pulse width variations in a pulse train.Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide 157