Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide

18 Utility Settings1 Write the following information on a tag and attach it to theoscilloscope.• Name and address of owner.• Model number.• Serial number.• Description of service required or failure indication.2 Remove accessories from the oscilloscope.Only return accessories to Agilent Technologies if they are associatedwith the failure symptoms.3 Package the oscilloscope.You can use the original shipping container, or provide your ownmaterials sufficient to protect the instrument during shipping.4 Seal the shipping container securely, and mark it FRAGILE.Configuring the [Quick Action] KeyThe [Quick Action] key lets you perform common, repetitive actions bypressing a single key.To configure the [Quick Action] key:1 Press [Utility] > Quick Action > Action; then, select the action that should beperformed:• Off — disables the [Quick Action] key.• Quick Measure All — displays a popup containing a snapshot of all thesingle waveform measurements. The Source softkey lets you select thewaveform source (which also becomes the source selection in theMeasurement Menu). See Chapter 13, “Measurements,” starting onpage 163.• Quick Print — prints the current screen image. Press Settings to set upthe printing options. See Chapter 17, “Print (Screens),” starting onpage 215.• Quick Save — saves the current image, waveform data, or setup. PressSettings to set up the save options. See Chapter 16, “Save/Recall(Setups, Screens, Data),” starting on page 201.234 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide