Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide

Agilent InfiniiVision 2000 X-Series OscilloscopesUser's Guide6Digital ChannelsTo connect the digital probes to the device under test 79Acquiring waveforms using the digital channels 83To display digital channels using AutoScale 83Interpreting the digital waveform display 84To switch all digital channels on or off 86To switch groups of channels on or off 86To switch a single channel on or off 86To change the displayed size of the digital channels 85To reposition a digital channel 87To change the logic threshold for digital channels 86To display digital channels as a bus 88Digital channel signal fidelity: Probe impedance and grounding 91To replace digital probe leads 96This chapter describes how to use the digital channels of a Mixed- SignalOscilloscope (MSO).The digital channels are enabled on MSOX2000 X- Series models andDSOX2000 X- Series models that have the DSOX2MSO upgrade licenseinstalled.To connect the digital probes to the device under test1 If necessary, turn off the power supply to the device under test.79